DEI 508D MANUAL PDF

August 1, 2019 posted by

I’d like to hook up a DEI D Field Proximity Sensor to an Arduino. This is the “manual”: Manual or automatic transmission selection. Note: In the case of D, power and ground must be hardwired to the . DEI feature error. Protect your vehicle with an invisible sensing field which detects moving high- density objects (including people) near your car using Radio Frequency (RF) field.

Author: Tygojind Murr
Country: Nepal
Language: English (Spanish)
Genre: Medical
Published (Last): 14 September 2015
Pages: 322
PDF File Size: 1.90 Mb
ePub File Size: 19.68 Mb
ISBN: 471-5-59039-781-8
Downloads: 10688
Price: Free* [*Free Regsitration Required]
Uploader: Grokinos

If only the latter works and gives That means it’s grounding, right? If 12V you’d need a level shifting circuit such as resistor divider.

Check the PDF Manual: Open-collector or open-drain, same thing outputs are nice and flexible like this you can wire several of them together to one pull-up resistor to make a hard-wired AND gate too. Dej I found good input to the initial problem under: Hmm, rather unclear that document and my neck now aches I think it might mean the outputs are open-collector capable of mA sink.

  APPARATO ESCRETORE PDF

Thanks for your help! It’s a 12V circuit, it has two outputs which I’d like to sense.

DEI Viper 508d Manual and Advice?

When the alarm is triggered the signal pin is connected to ground. MarkT Brattain Member Posts: When I first tried hooking this up to my Arduino I was worried about the sensor running on 12v. Without a resistor, it measures 0V when inactive, about 6. The blue wire is “alarm” – someone’s entered the smaller alarm manuaal. With a 10K resistor connected between the output and the 16V rail sorry, no 5V available right nowit reads 15V at the output when inactive, but drops to zero when triggered.

If both generate an output then take note of the voltages 58d.

Eventually I realized that the signal pins are left floating when the alarm is not triggered. I’m also trying to use this sensor, but confused about what the blue and green wires do.

This means you can connect the signal pin to a Arduino digital input pin, but you need to connect it to a pull up resistor so you get a constant value. Measure the output voltages with nothing connected, and then again with 10k resistor from output to 5V.

  ITOP 4-2-602 PDF

How would I sense that, and is it OK to connect that ddei directly to the Arduino’s 5V power even though this runs on car 12V? Now I’m starting to see what the term “pull-up resistor” actually means! I took a few electronics courses back in college, but have forgotten most of it.

DEI Viper d Manual and Advice?

Great, thanks so much for your help! I know thread is old. Is there something I can read online to get a better understanding? I didn’t want to pass that voltage into the Arduino and fry it. This is the “manual”: However I’d suggest it would be best to measure.