FUTABA 3PK MANUAL PDF
Channel radio control system instruction manual • Read online or download PDF • Futaba 3PK User Manual. View and Download FUTABA 3PK instruction manual online. 3-CHANNEL RADIO CONTROL SYSTEM. 3PK Remote Control pdf manual download. View and Download FUTABA 3PKS instruction manual online. download. Also for: Magnum 3pk super. Remote Control FUTABA 3PK Instruction Manual.
|Published (Last):||21 October 2005|
|PDF File Size:||7.82 Mb|
|ePub File Size:||14.81 Mb|
|Price:||Free* [*Free Regsitration Required]|
Page 64 Programmable Mixes: The reset method can be selected from among the 3 types described below.
Device used to recharge batteries. X and Y ratio Y: While pressing this part. If your servos are too far away to plug into the receiver, use an extension cord to extend the length of the servo lead. Comments to this Manuals Your Name. Other Futabq Always use only genuine Futaba transmitters, receivers, servos, FET amps electronic speed controls ,Nicad batteries and other optional accessories.
Moves throttle servo to a preset position which closes the carburetor ,anual shuts off the engine.
Download Instructions Manuals: Futaba 3PK Radio control
Changing wheel position 1. Connect and install the receiver and servos in accordance with “Installation Safety Precautions” on the next page. Ni-cad Battery Replacement The Ni-cad battery is connected by a connector so that it can be removed when you will not be using the transmitter for a long time, or when replacing a dead battery with a spare battery.
The total time does not change even when the model changes. Don’t show me this message again.
Futaba 3PK GHz User Manual | 2 pages
Make an exact copy of a model for backup, to copy to CAMPac to use in another radio, etc. User name display When the END button is held down for 1 second or longer at the initial screen, the Futaba logo and user name are displayed for about 2 seconds.
Forward side rate Switching point TG. Set up a lap memory timer to track lap times Assign desired lapstart and restart switches.
Level lv3 only servo view servo – Futaba 3PK User Manual
However, when correction was executed, it may be necessary to recheck the set values of all the setup functions. A rigid, short antenna mounted to the model. The use of other than Futaba crystal will result in decrease of range as well as loss of control. It is not intended for use in any ap- plication other than the control of models for hobby and recreational purposes.
Synthesizer Receiver Rfhs Always use only genuine Futaba transmitters, receivers, servos, FET amps electronic speed controls ,Nicad batteries and other optional accessories.
Always try to setup your ESC normally first. Throttle servo CH2 3: Color for LED lamp is adjustable. Model names may be the same between models; model will still be displayed and will nanual be different.
Futaba 3PK 2.4GHz User Manual
Open the front cover for a directory of features, or open this rear cover for quick set-up tips for nitro engines and when to use which feature! Dual rate is always active, except when the 2nd dual rate switch is pushed.
After you followed the suggestions listed and the problem is not corrected return the system to our service department for inspection and repair. When the servo operation position is not set, this function operates so that the servos remains in the position they were in immediately before futabaa was lost.
Setting the throttle speed function reduces wasteful battery consumption while at the same time permitting smooth, enjoyable operation.
Dual rate is always active, except when fugaba 2nd dual rate switch is pushed. Nicad Battery Handling Precautions Only when Nicad batteries are used Warning Always check to be sure your batteries have been charged prior to operating the model. Negative exponential makes the servo less responsive around center; Remove the module by pulling it upward while pushing the left and right tabs to the inside.